Stealth R/T Turbo V6-2972cc 3.0L DOHC Turbo (1996)
Idle Switch Check For No Continuity
6. Slowly turn the throttle position sensor clockwise until you find a point at which there is no continuity across terminals 3 and 4. Then, tighten the
throttle position sensor mounting bolt securely.
7. Connect the throttle position sensor connector.
8. Connect the scan tool to the data link connector.
9. If not using the scan tool, proceed as follows:
^
Disconnect the throttle position sensor connectors and connect the special tool, Test Harness Set, between the disconnected connectors.
^
Connect a digital voltmeter between the throttle position sensor terminal 2 (sensor output) and terminal 4 (sensor ground).
10. Turn the ignition switch "ON" (but do not start the engine).
11. Check the throttle position sensor output voltage.
Standard value: 400 - 1,000 mV
12. If the voltage is out of specification, check the throttle position sensor and associated harnesses.
13. Remove the feeler gauge.
14. Turn the ignition switch "OFF".
