Stealth R/T Turbo V6-2972cc 3.0L DOHC Turbo (1996)
Differential Carrier: Service and Repair
Differential Carrier Disassembly
Disassemble differential assembly in numbered sequence shown, noting the following:
Fig.38 Exploded View Of Differential Carrier
1. Refer to "Pre-Disassemble Inspection procedure.
2. Using spanner wrench tool No. MB991367 and pin tool No. MB991385, or equivalent, remove side bearing nut.
3. Using a suitable press, push differential case until it is pressed against the carrier.
4. Remove differential case from press. Insert two spacers in diagonally opposite positions between side bearing outer race to be removed and inner
race. Using a press, remove outer race.
CAUTION:
Do not allow side bearing to drop. Keep right and left bearings separate. Use a spacer 1.18 inches long, 0.39 inch wide and 0.04-0.08 inch high
made of copper to prevent damage to bearings.
5. Pull out side bearing inner races by using suitable bearing puller.
6. Scribe alignment marks on differential case and drive gear. Loosen drive gear bolts in diagonal sequence to remove drive gear.
7. Using end yoke holder tool MB990767-01, or equivalent, remove companion flange self-locking nut.
8. Scribe alignment marks on drive pinion and companion flange. Remove out drive pinion together with drive pinion spacer and shims.
Marks should not be made on contact surfaces of companion flange and shaft.
9. Pull out drive pinion bearing inner races by using insert tool, pinion carrier bearing puller tool, and side bearing cup remover step plate tool or
equivalent.
10. Drive out drive pinion front and rear bearing from gear carrier.
