Stealth R/T Turbo V6-2972cc 3.0L DOHC Turbo (1996)
Fig.26 Rear Wheel Bearing Rotation Sliding Resistance Check
4. Attach a spring balance to hub bolt, then pull balance at a right angle to bolt. Measure rotation starting torque.
5. If rotation starting torque is less than 6 inch lbs., bearing is satisfactory.
6. If rotation starting torque is more than 6 inch lbs., ensure tightening torque of axle shaft companion flange nut is as follows:
a. Ensure torque is 116-159 ft. lbs. on Laser and 1994 Talon.
b. Ensure torque is 137 ft. lbs. on Stealth less turbo.
c. Ensure torque is 188-217 ft. lbs. on Stealth with turbo.
7. If torque is satisfactory, replace wheel bearing.
Limited Slip Differential Check
1. Block front wheels and move shift lever to neutral.
2. Release parking brake completely, then raise rear wheels and support with rigid jack stand.
3. Disconnect coupling of differential and propeller shaft.
4. Rotate one wheel slowly, ensure wheel on opposite side turns in the same direction.
5. If wheel turns in the opposite direction, replace viscous unit.
