Stratus L4-2.0L VIN C (1997)
CAUTION: When removing the routing clip and brake tubes from the mounting stud, do not bend or kink the chassis brake line tubes.
Master Cylinder Mounting To Vacuum Booster
5. Slide the master cylinder straight off its mounting studs on the vacuum booster.
INSTALL
1. Position master cylinder assembly on studs of power brake unit, aligning push rod on power brake vacuum booster with piston of master cylinder.
CAUTION: When installing the routing clip and brake tubes on the mounting stud, do not bend or kink the chassis brake line tubes. Be sure the
chassis brake tubes are routed correctly. The chassis brake tubes can not touch each other or other components or the body of the vehicle.
2. Install the 2 master cylinder to power brake vacuum booster mounting nuts. Tighten both nuts to a torque of 28 Nm (250 in. lbs.).
3. Connect brake tubes to master cylinder primary and secondary ports. Then tighten the tube nuts to a torque of 17 Nm (145 in. lbs.).
4. Install the connector from the vehicle wiring harness on the fluid level sensor in the master cylinder fluid reservoir.
