Stratus L4-2.0L VIN C (1997)
Fig. 6 Re-Usable Throttle Body Gasket
9. The rubber 0-ring gasket on the intake manifold is reusable. Wipe the 0-ring clean before installing throttle body Fig. 6.
INSTALLATION
1. Attach electrical connectors to idle air control motor and throttle position sensor.
2. Position throttle body on intake and install mounting bolts. DO NOT tighten bolts at this time.
3. Install throttle cable bracket. DO NOT tighten bolts at this time.
4. Tighten throttle body bolts to 22.5 ± 3 Nm (200 ± 25 in. lbs.) torque.
5. Tighten throttle cable bracket bolts to 11.75 ± 2.25 Nm (105 ± 20 in. lbs.) torque.
6. Install EVAP purge hose to throttle body nipple.
7. Install cable housing(s) retainer tabs into bracket.
8. Install throttle body cables by rotating the throttle lever forward to the wide open position Fig. 4.
9. Install air inlet resonator.
