Stratus L4-2.0L VIN C (1997)
6. Loosen screw attaching target magnet to rear of camshaft Fig. 7.
NOTE: The target magnet has two locating dowels that fit into machined locating holes in end of the camshaft Fig. 8.
INSTALLATION
1. Install target magnet in end of camshaft. Tighten mounting screw to 3 Nm (30 in lb) torque.
2. Install camshaft position sensor. Tighten sensor mounting screws to 9 Nm (80 in lb) torque.
3. Attach electrical connectors to coolant temperature sensor and camshaft position sensor.
4. Install air cleaner inlet tube and filtered air tube.
