Stratus L4-2.0L VIN C (1997)
Fig. 9
14. On a vehicle equipped with antilock brakes, clip the vehicle wiring harness back on the right frame rail. The route wiring harness connector for the
wheel speed sensor cable through routing hole in inner fender. Connect vehicle wiring harness to wheel speed sensor cable.
Fig. 8
15. On a vehicle equipped with antilock brakes, install wheel speed sensor cable sealing grommet in routing hole. Install retainer for wheel speed sensor
cable grommet on right inner fender.
16. On a vehicle not equipped with antilock brakes, install sealing plug back in routing hole.
17. Install accessory drive slash shield in right front inner fender.
18. Install tire back on vehicle. Tighten the wheel lug nuts in proper sequence until all lug nuts are torqued to half specification. Then repeat tightening
sequence to full specified torque of 129 Nm (95 ft. lbs.).
19. Lower vehicle.
CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar (R), Power Steering Fluid, or equivalent.
20. Fill power steering reservoir to correct fluid level.
