Stratus L4-2.0L VIN C (1997)
11. Remove the coil spring and the spring compressor as an assembly from the shock absorber. Mark left and right springs for installation back on
correct side of vehicle.
Fig. 47
12. Remove the jounce bumper and the collar from the rod of the shock absorber assembly.
13. Remove the coil spring isolator from the lower spring seat on the shock absorber assembly.
14. Inspect the shock absorber for any condition of shaft binding over full stroke of the rod.
15. Inspect all disassembled components for signs of abnormal wear or failure, replacing any components as required. Inspect shock absorber for signs
of abnormal oil leakage and for loss of gas charge. To check for loss of gas charge in shock absorber, push the shaft of the shock absorber in and
release, the shaft should return to its fully extended position. If shaft does not return to its fully extended position replace shock absorber.