Stratus L4-2.0L VIN C (1997)
8. Pull up on parking brake handle. Pull up on rear of console and remove console.
9. Remove floor pan grommet from floor pan.
10. Remove cable retaining clips at shifter.
CAUTION: It is recommended that new cable retaining clips be used for reinstallation.
11. Disconnect shift cables from shifter. Pry with equal force on both sides of shifter cable isolator bushings to avoid damaging bushings.
12. Lift vehicle on hoist. Pry shift cable grommet from floor pan.
13. Detach cables from cable support clips.
14. Remove shift cables from vehicle.
INSTALLATION
To install, reverse removal procedure. After cables have been replaced, cable adjustment should be checked. Refer to cable adjustment procedure
in this section.
CAUTION: Only the crossover cable is adjustable. The selector cable does not have any adjustment capabilities.
