Stratus L4-2.4L DOHC (1995)
Keyless Entry Transmitter: Service and Repair
Programming an RKE Transmitter
Two (2) Button Transmitters
TWO (2) BUTTON TRANSMITTERS
To program an RKE transmitter, use the DRB and select "Body Computer", then "Miscellaneous", then "Program RKE". Push any button on the
transmitter. The locks will lock or unlock to indicate that the BCM has received a useable code and will store it. If another transmitter is to be
programmed, re-enter and repeat the steps.
The BCM is capable of storing up to four transmitter codes. If an attempt to program a fifth transmitter is received, the DRB will inform that "All
Locations Are In Use" and ask if you want to cancel them. If you answer yes, it will inform you that it is in programming mode. Press any button
on a transmitter that you want to keep in memory. If you exit after answering yes, it will retain only the first transmitter code and cancel all others.
Four (4) Button Transmitters
FOUR (4) BUTTON TRANSMITTERS
Using the DRB select "Body Computer", then "Miscellaneous" then "Program RKE". Press Lock and Decklid Release buttons simultaneously and
hold for 5 seconds. All doors will unlock and will activate illuminated entry (if equipped) to indicate that the code has been programmed into the
BCM's memory. Follow the same procedure for programming additional transmitters.
A maximum of 4 transmitters can be programmed into the BCM at one time. If an attempt to program a fifth transmitter is received, the DRB will
inform that "All Locations Are In Use" and ask if you want to cancel them. If you answer yes, it will inform you that you are in programming
mode at which time you will program transmitters you want to keep in memory. If you exit after answering "Yes", it will retain only the first
transmitter code and cancel all others.
