Stratus L4-2.4L DOHC (1995)
8.
Disconnect six-way wiring connector at the rear of the HCU. Depress the locking tab and slide the wiring connector off of the HCU bracket
retaining clip (Figure 12).
9.
Unwrap tape from the HCU half of the wiring connector to expose open end of the convolute.
10.
Attach provided nozzle to tube of grease.
11.
Insert grease tube nozzle into HCU end of wiring harness convolute until it bottoms at HCU. Inject entire contents of grease tube into wiring
convolute so that HCU solenoid cavity fills with grease (Figure 13).
12.
Wrap tape around HCU half of the wiring connector and convolute.
13.
Slide wiring connector onto HCU bracket retaining clip. Reconnect HCU six-way wiring connector.
14.
Install HCU heat shield.
15.
Lower vehicle from hoist.
16.
Verify that no brake fluid leaks exist and road test vehicle to assure proper brake operation.
