Stratus L4-2.4L DOHC (1995)
20.
Verify proper brake warning lamp operation by removing the reservoir cap and using the provided dowel rod (make sure rod is clean) to push the
float to the bottom of its travel (Figure 8). With the key in the ON position and the float at the bottom of its travel the warning light should be
illuminated. Reinstall reservoir cap.
21.
With engine off, pump brake pedal about 3-4 times until all vacuum in power brake booster is depleted. Apply light brake pedal pressure and hold
for a minimum of 30 seconds. The brake pedal should remain firm. Apply heavy brake pedal pressure and hold for a minimum of 30 seconds.
Again, the brake pedal should remain firm. If the brake pedal drops or is not firm during either of these tests, the master cylinder may either have a
damaged piston assembly or it was not properly bled and must be repaired accordingly.
22. Speed control equipped vehicles: Install speed control servo and tighten nuts securely.
23. 2.4L engine equipped vehicles: Install air cleaner resonator/housing.
24. Verify that no brake fluid leaks exists and road test vehicle to assure proper brake operation.
Owner Letter
SAFETY RECALL To INSPECT AND REPAIR YOUR VEHICLE'S BRAKE MASTER CYLINDER
Dear Chrysler Vehicle Owner:
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
Chrysler Corporation has determined that a defect which relates to motor vehicle safety exists in some 1995 and 1996 Dodge Stratus, Dodge/Plymouth
Neon, Chrysler Cirrus and 1996 Plymouth Breeze vehicles.
The Problem is...
The master cylinder rear piston seal on your vehicle (identified on the enclosed form), may leak and cause a partial brake system loss. The brake warning
light will turn on to signal system impairment. If this warning is ignored, an increase in stopping distance could result in an accident.
What Chrysler and your dealer will do...
Chrysler will repair your vehicle free of charge (parts and labor). To do this, your dealer will inspect your brake master cylinder and if necessary, replace
the primary piston and seal assembly. The work will take about one hour to complete. However, additional time may be necessary depending on how
dealer appointments are scheduled and processed.
What you must do to ensure your safety...
^
Simply contact your dealer right away to schedule a service appointment. Ask the dealer to hold the parts for your vehicle or to order them before
your appointment.
^
Bring the enclosed Owner Notification Form with you to your dealer. It explains the required service to the dealer.
If you need help...
If you have trouble getting your vehicle repaired, please call the Chrysler Customer Center, toll free, at 1-800-853-1403. A representative will assist you
in getting your vehicle repaired. If your dealer fails or is unable to remedy this defect without charge and within a reasonable time, you may submit a
