Stratus L4-2.4L DOHC (1995)
Balance Shaft: Service and Repair
Chain Tensioning
1. Install chain tensioner loosely assembled.
2. Position guide on double ended stud making sure tab on the guide fits into slot on the gear cover. Install and tighten nut/washer assembly to 12 Nm
(105 inch lbs.).
3. Place a shim 1 mm (0.039 inch) thick x 70 mm (2.75 inch) long or between tensioner and chain. Push tensioner and shim up against the chain.
Apply firm pressure (5.5 to 6.6 lbs.) directly behind the adjustment slot to take up all slack. Chain must have shoe radius contact as shown.
4. With the load applied, tighten top tensioner bolt first, then bottom pivot bolt. Tighten bolts to 12 Nm (105 inch lbs.). Remove shim.
5. Install carrier covers and tighten screws to 12 Nm (105 inch lbs.).
