dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C System - Intermittently or Totally Inoperative|Page 8962 > < A/C - Does Not Blow Cold Enough Air|Page 8957
Page 1
background image

Refrigerant Pressure Sensor / Switch: All Technical Service Bulletins
A/C System - Intermittently or Totally Inoperative

NO: 24-14-94

GROUP: Air Conditioning

DATE: Oct. 7, 1994

SUBJECT:

Inoperative A/C System

MODELS:

1993 - 1995

(LH)

Concorde/Intrepid/Vision/LHS/New Yorker

1995

(JA)

Cirrus/Stratus

SYMPTOM/CONDITION:

Intermittent or total loss of air conditioning.

DIAGNOSIS:

Check Engine Diagnostic Trouble Codes (DTC's) with Mopar Diagnostic System (MDS) or Diagnostic Readout Box (DRB) for the presence of a High
Pressure Fault or Low Pressure Fault. If the readings are taken during system malfunction and both high and low pressure fault readings are above 439
PSI, verify readings with a gauge set. If the low pressure reading is validated by a gauge set, the system should be checked for a low charge and
refrigerant added as necessary. If readings are not validated by a gauge set, perform the repair procedure.

PARTS REQUIRED:

1

4723028

A/C Pressure Transducer Package ("Certified")

REPAIR PROCEDURE:

This bulletin involves replacing the A/C pressure transducer.

1.

Disconnect the wire harness connector from the A/C pressure transducer.

NOTE:

A SLIGHT RELEASE OF PRESSURE TRAPPED IN THE FITTING MAY BE EXPERIENCED. IT IS NOT NECESSARY TO DISCHARGE
THE REFRIGERANT SYSTEM.

2.

Remove the transducer with a counterclockwise rotation using a 3/4" open end wrench.

3.

Install "certified" transducer and torque to 6 N-m (50 in.lbs.) using new O-ring provided.

4.

Connect wire harness connector.

A/C System - Intermittently or Totally Inoperative|Page 8962 > < A/C - Does Not Blow Cold Enough Air|Page 8957