Stratus L4-2.4L DOHC (1995)
ABS Light: Description and Operation
The Antilock Brake System (ABS) warning lamp located on the instrument cluster will turn on when the CAB detects a condition which results in a
shutdown of the ABS function.
The ABS warning lamp will turn on for approximately four-five seconds after the ignition key is switched to the ON position. During this time the CAB
runs a system self test.
The ABS warning lamp is an output from the ABS control module and the ABS relay box. It is used to alert the operator of a problem in the ABS
system. The G19 circuit from the ABS controller and the ABS system relay is used to detect a problem. If a problem is detected, the ABS control module
grounds the G19 circuit and illuminates the lamp in the instrument cluster.
Circuit G19 is also an output of the controller to the ABS system relay contact side.
The Anti-Lock Brake (ABS) system warning lamp is used to alert the operator of a problem in the system. When the ABS controller determines a
problem in the system it grounds the G19 circuit and illuminates the lamp. Power for the lamp is supplied on the F18 circuit. This circuit also powers the
engine oil pressure lamp, located internal to the cluster, high speed fan relay, A/C C1utch relay, and the Powertrain Control Module (PCM). This circuit
is protected by a 10 amp fuse located in cavity 9 of the Power Distribution Center (PDC).
