Stratus L4-2.4L DOHC (1995)
Canister Purge Solenoid: Testing and Inspection
EVAP Purge Solenoid Inspection
EVAPORATIVE EMISSION PURGE SOLENOID INSPECTION
NOTE: When disconnecting the vacuum hose, place an identification mark on it for proper re-connection.
1. Disconnect the vacuum hose from the solenoid valve.
2. Disconnect the harness connector.
3. Connect a hand vacuum pump to nipple (A) of the solenoid valve.
4. Check airtightness by applying a vacuum with voltage applied directly from the battery to the purge control solenoid valve.
Battery Voltage / Normal Condition.
Applied ................................................................................................................................................................................................. Vacuum Leaks
Not Applied ................................................................................................................................................................................. Vacuum Maintained
5. Measure the resistance between the terminals of the solenoid valve.
-
Standard value: 25-35 ohms [at 20°C (68°F)]