Stratus L4-2.4L DOHC (1995)
13.
Twist all three leads together and solder the splice with rosin core solder. Slide the heat shrink tube over the splice and shrink with a heat gun until
sealant flows from both ends of the shrink tubing.
14.
Reinstall the wire dress cover to the rear of the C1 connector. Using electrical tape p/n 04778138, tape over the repaired area to match the original
construction of the harness finishing the tape on the tape flange of the wire dress cover.
15.
Reconnect the oxygen sensor to its harness and the C1 connector to the powertrain control module.
16.
Reconnect the battery negative cable.
17.
Verify the wiring repair by running the oxygen sensor test with the DRB III.
