Stratus L4-2.4L VIN X (1998)
Brake Drum And Hub And Bearing Assembly
3. Remove rear brake drum from the rear hub and bearing assembly.
INSTALL
1. Install rear brake drum on rear hub and bearing assembly.
2. Install the wheel and tire assembly.
3. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 129 Nm (95 ft. lbs.).
4. Adjust rear brakes. The rear brakes on this vehicle are adjusted by depressing the brake pedal as far as possible 2 or 3 times.
