Stratus L4-2.4L VIN X (1998)
Park Brake Lever Output Cable Adjustment
-
Tighten adjusting nut on park brake lever output cable until 12 mm millimeters of thread is out past top edge of adjustment nut.
-
Actuate the park brake lever to its fully applied position (22 clicks) 1 time and then reposition lever to its fully released position.
Actuating the park brake lever to its fully applied position 1 time after tightening the adjustment nut will yield (stretch) the bent nail portion of
the tension equalizer approximately 1/4 inch. This process will correctly set the park brake cable tension.
7. Check the rear wheels of the vehicle with the park brake lever fully released, they should rotate freely without dragging.
8. After the park brake cable tension has been properly adjusted, check for free play in park brake lever. Park brake hand lever should feel firm at all
clicks, with a maximum of 22 clicks of lever travel possible.
9. Install the center console back in the vehicle.
10. Install the 2 screws attaching the front of the center console to the forward console.
11. Install screws attaching rear of center console assembly to console bracket.
12. Install the shifter boot or PRNDL plate back in the center console.
13. Install the shift knob on the shifter.
