Stratus L4-2.4L VIN X (1998)
Input Rod Retaining Pin
10. Locate the power brake vacuum booster input rod to brake pedal attachment under instrument panel. Position a small screwdriver between the
center tang on the power brake booster input rod to brake pedal pin retaining clip. Rotate screwdriver enough to allow retaining clip center tang to
pass over end of brake pedal pin. Then pull retaining clip off brake pedal pin. Discard retaining clip. Replace only with a new retaining clip when
assembled.
Power Brake Booster Mounting
11. Remove the 4 nuts attaching power brake vacuum booster to dash panel. Nuts are accessible from under dash panel in area of the steering column
and pedal bracket assembly.
Power Brake Vacuum Booster
12. Slide power brake vacuum booster forward until mounting studs clear dash panel and then tilt up and rotate toward center of vehicle to remove.
CAUTION: Do not attempt to disassemble the power brake vacuum booster it is to be serviced ONLY as a complete assembly.
