Stratus L4-2.4L VIN X (1998)
Engine Mount: Service and Repair
Right/Engine Support Bracket
NOTE:
The right side engine mount is a Hydro-Mount and may show surface cracks. This will not effect it's performance and should not be replaced. Only
replace the Hydro-Mount when it's leaking fluid.
Engine Mounting-Right Side
1. Raise vehicle on a hoist and remove inner splash shield. Remove the right engine support assembly vertical fasteners from frame rail.
2. Lower vehicle. Remove the load on the engine motor mounts by carefully supporting the engine assembly with a floor jack.
3. Remove the three bolts attaching the engine support assembly to the engine bracket.
4. Move the air conditioning dryer aside.
5. Remove coolant recovery system tank.
6. Remove right engine support.
7. Remove the three bolts attaching the engine support bracket to the cylinder block.
NOTE: If centering or adjusting the engine/transmission assembly is needed refer to Adjustments.
8. Reverse removal procedure for installation.
