dodge Workshop Repair Guides

Dodge Stratus L4-24L VIN X Workshop Service and Auto Repair Manuals

Hose/Line HVAC|Service and Repair > < High Pressure Safety Valve HVAC|Description and Operation
Page 1
background image

Hose/Line HVAC: Description and Operation

SYSTEM OPERATION

The air conditioning lines used on this vehicle are made from reinforced rubber with a nylon liner on the inner walls. The ends of the A/C lines are
made with light weight aluminum fittings or quick connects.

The A/C lines use special connectors called quick connects. There are four quick connects in the system. Two are located at the condenser and the
other two are located at the expansion valve. Each quick connector has a clip installed on it.

CAUTION:  Never attempt to remove a clip or disconnect a quick connect without reclaiming all refrigerant from the air conditioning system.
The system must be empty.

All quick connects use two O-rings to seal the connection. The O-rings are made from a special type of rubber that is not affected by R-134a 
refrigerant. O-ring replacement is required whenever lines are removed and installed. Use only O-rings specified for this vehicle. Failure to use the
correct type of O-ring will cause the connection to leak within a short period of time.

When it is necessary to open the refrigeration system, have everything needed to service the system ready. The system should not be left open any
longer than necessary Cap or plug all lines and fittings as soon as they are opened. This will prevent the entrance of dirt and moisture into the
system. All new lines and components should be capped or sealed until they are ready to be used.

WARNING:
-

AVOID BREATHING NC REFRIGERANT AND LUBRICANT VAPOR OR MIST. EXPOSURE MAY IRRITATE EYES, NOSE
AND THROAT. USE ONLY APPROVED SERVICE EQUIPMENT MEETING SAE REQUIREMENTS TO DISCHARGE R-134a
SYSTEM. IF ACCIDENTAL SYSTEM DISCHARGE OCCURS, VENTILATE WORK AREA BEFORE RESUMING SERVICE.

-

R-134a SERVICE EQUIPMENT OR VEHICLE A/C SYSTEM SHOULD NOT BE PRESSURE TESTED OR LEAK TESTED
WITH COMPRESSED AIR. SOME MIXTURES OF AIR/R-134a HAVE BEEN SHOWN TO BE COMBUSTIBLE AT ELEVATED
PRESSURES. THESE MIXTURES ARE POTENTIALLY DANGEROUS AND MAY RESULT IN FIRE OR EXPLOSION
CAUSING INJURY OR PROPERTY DAMAGE
.

Hose/Line HVAC|Service and Repair > < High Pressure Safety Valve HVAC|Description and Operation