Stratus L4-2.4L VIN X (1998)
Horn Switch: Service and Repair
Horn Contact Switch
REMOVAL
WARNING: BEFORE BEGINNING ANY AIRBAG SYSTEM REMOVAL OR INSTALLATION PROCEDURES, REMOVE AND
ISOLATE THE BATTERY NEGATIVE CABLE FROM THE VEHICLE BATTERY. THIS IS THE ONLY SURE WAY TO DISABLE
THE AIRBAG SYSTEM. FAILURE TO DO THIS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Disconnect and isolate battery negative cable in engine compartment.
2. Remove the screws that attach the Driver Airbag Module to the steering wheel.
3. Lift the module to gain access and disconnect the squib wire.
4. Place Driver Airbag Module on a clean level surface with pad facing upward.
5. If the contact area is bad, replace Driver Airbag Module. If the mounting bracket or bushings are bad, replace steering wheel.
INSTALLATION
-
For installation, reverse the above procedures. Use caution not to pinch wires.
