Stratus L4-2.4L VIN X (1998)
Speed Sensor Head Attachment To Steering Knuckle
5. Remove bolt attaching speed sensor to steering knuckle. Then remove speed sensor head from steering knuckle
CAUTION: If speed sensor head locating pin has seized to the steering knuckle, do not attempt to remove speed sensor head by grasping with
pliers and turning. This will damage the speed sensor head. Use only the following procedure.
Speed Sensor Head Removal From Steering Knuckle
6. If speed sensor head can not be removed from steering knuckle by hand, the locating pin on the speed sensor head has seized to the steering
knuckle do to corrosion. Remove speed sensor head from steering knuckle using the following procedure. Remove disc brake caliper from steering
knuckle, and remove brake rotor from hub/bearing assembly. Then insert a pin punch through hole in front steering knuckle and tap speed sensor
head locating pin out of steering knuckle.
INSTALL
CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers.
Failure to install cables in retainers as shown ay result in contact with moving parts and/or over extension of cables, resulting in an open circuit.
1. Connect the wheel speed sensor cable connector to the vehicle wiring harness.
2. Install the speed sensor cable assembly grommet into the front inner fender. Install speed sensor cable grommet retainer/routing bracket on the
inner fender of the vehicle and install and securely tighten attaching bolt.
