Stratus L4-2.4L VIN X (1998)
16.
Install the shift bezel and boot.
17.
If required, install the radio bezel.
18.
Install the shift handle and tighten the set screw.
19.
Check for proper shifter and ignition/park interlock operation.
C. Floor Shifter Replacement
NOTE:
Only those vehicles with an inoperative ignition/park interlock, as determined by the inspection in Section "A," require shifter replacement.
New shifter assemblies already contain the load limiting push rod.
1.
Disconnect the negative battery cable.
2.
Secure the vehicle to prevent it from rolling during this service procedure.
3.
Insert the key into the ignition and turn to "RUN" position.
4.
Place shift lever into the full rearward position.
5.
Using an allen wrench, loosen the set screw in shift handle (Figure 2).
6.
Remove the shift handle from the shift lever.
7.
Remove the shift bezel and/or boot (Figure 7).
NOTE:
Some models may require the removal of the radio bezel to gain access to the shift bezel and boot.
8.
With the shifter in the "PARK" position, disconnect the gearshift cable from the cable attaching stud (pin).
9.
If the gearshift cable anchor bracket is part of the shifter, remove the gear shift cable retaining clip from the shifter base slot and remove the cable
(Figure 7).
