Stratus L4-2.4L VIN X (1998)
2. Remove the power steering pump discharge/ flow control valve fitting from the power steering pump housing. Use care to prevent the flow control
valve and spring from sliding out of the discharge/flow control valve fitting.
3. Remove and discard O-ring seal from fitting.
INSTALLATION
1. If necessary, clean and install flow control valve and spring in pump housing bore.
2. Install new O-ring seal on fitting.
3. Install the discharge/flow control valve fitting into the power steering pump. Tighten the discharge/flow control valve to a torque of 75 Nm (65 ft.
lbs.).
4. Install power steering fluid pressure hose on flow control valve fitting. Tighten the tube nut to a torque of 31 Nm (275 inch lbs.).
Power Steering Pump Initial Operation
WARNING: The fluid level should be checked with engine off to prevent injury from moving components. Use only Mopar (R) Power Steering Fluid.
Do not use automatic transmission fluid. Do not overfill.
Wipe filler cap clean, then check the fluid level. The dipstick should indicate FULL COLD when the fluid is at normal temperature of approximately 21°
C to 27°C (70°F to 80°F).
1. Fill the pump fluid reservoir to the proper level and let the fluid settle for at least two (2) minutes.
2. Start the engine and let run for a few seconds. Then turn the engine off.
3. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
4. Raise the front wheels off the ground.
5. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops.
6. Add power steering fluid if necessary.
7. Lower the vehicle and turn the steering wheel slowly from lock to lock.
8. Stop the engine. Check the fluid level and refill as required.
9. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
Power Steering Pump Mounting Bracket Replacement
DISASSEMBLE
1. Remove power steering pump from engine.
CAUTION: Do not hammer on power steering pump pulley or shaft to remove power steering pump pulley. This will damage the pulley and the
power steering pump.
