Stratus L4-2.4L VIN X (1998)
10. Install the shock absorber mounting bracket and isolators as an assembly on the rod of the shock absorber assembly.
11. Install the top washer on rod of shock absorber and position it over shock absorber mount. Washer must be installed with the word TOP stamped
into washer facing up.
WARNING: The following 2 steps must be completely done before spring compressor is released from the coil spring.
12. Install nut on rod of shock absorber assembly. Install Shock Absorber Socket, Snap-On A136 or an equivalent on end of shock rod to keep rod
from turning. Then tighten rod nut using a crowfoot to a torque of 55 Nm (40 ft. lbs.).
