Stratus L4-2.4L VIN X (1998)
Outer C/V Joint Installation On Interconnecting Shaft
3. Install outer C/V joint assembly onto interconnecting shaft by using a soft-faced hammer and tapping end of stub axle (with nut installed) until
outer C/V joint is fully seated on interconnecting shaft.
Outer C/V Joint Correctly Installed On Interconnecting Shaft
4. Outer C/V joint assembly must be installed on interconnecting shaft until cross of outer C/V joint assembly is seated against circlip on
interconnecting shaft.
5. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer C/V joint
assembly housing. Put the remaining amount into the sealing boot.
6. Install outer C/V joint sealing boot to interconnecting shaft clamp evenly on sealing boot.
Crimping Tool Installed On Sealing Boot Clamp
