Stratus L4-2.4L VIN X (1998)
4. Disconnect drive linkage from motor output crank. Using an ball joint/tie rod separator, separate the ball cap from the ball.
5. Remove motor mounting nuts and remove motor.
6. Disconnect wire connector at motor.
MOTOR ASSEMBLY INSTALLATION
-
For installation, reverse the above procedures. Tighten the mounting screws to 10 to 12 N.m (89 to 106 in. lbs.) torque. Ensure that the motor
connector seal is properly positioned. Tighten the motor mounting nuts to 25 to 30 N.m (19 to 23 ft. lbs.) torque.
