Stratus V6-2.5L VIN H (1997)
Cruise Control Switch: Description and Operation
SYSTEM OPERATION
There are two separate switch pods that operate the speed control system. The steering-wheel-mounted switches use multiplexed circuits to
provide inputs to the PCM for ON, OFF, RESUME/ACCELERATE, SET/COAST and CANCEL modes. Refer to the owner's manual for more
information on speed control switch functions and setting procedures.
when speed control is selected by depressing the ON switch, the PCM allows a set speed to be stored in RAM for speed control. To store a set
speed, depress the COAST/SET switch while the vehicle is moving at a speed between 30 and 85 mph. In order for the speed control to engage,
the brakes cannot be applied, nor can the gear selector be indicating the transmission is in Park or Neutral.
The speed control can be disengaged manually by:
-
Stepping on the brake pedal
-
Depressing the OFF switch
-
Depressing the CANCEL switch.
The speed control can be disengaged also by any of the following conditions:
-
An indication of Park or Neutral
-
The VSS signal increases at a rate of 10 mph per second (indicates that the co-efficient of friction between the road surface and tires is
extremely low)
-
An rpm increase without a VSS signal increase (indicates that the clutch has been disengaged)
-
Excessive engine rpm (indicates that the transmission may be in a low gear)
-
The VSS signal decreases at a rate of 10 mph per second (indicates that the vehicle may have decelerated at an extremely high rate)
-
If the actual speed is not within 20 mph of the set speed
The previous disengagement conditions are programmed for added safety. Once the speed control has been disengaged, depressing the
RES/ACCEL switch restores the vehicle to the target speed that was stored in the PCM's RAM.
NOTE: Depressing the OFF switch will erase the set speed stored in the PCM's RAM.
It, while the speed control is engaged, the driver wishes to increase vehicle speed, the PCM is programmed for an acceleration feature. With the
RES/ ACCEL switch held closed, the vehicle accelerates slowly to the desired speed. The new target speed is stored in the RAM when the
RES/ACCEL switch is released. The PCM also has a "tap-up" feature in which vehicle speed increases at a rate of approximately 2 mph for each
momentary switch activation of the RES/ACCEL switch.
The PCM also provides a means to decelerate without disengaging speed control. To decelerate from an existing recorded target speed, depress
and hold the SET/COAST switch until the desired speed is reached. Then release the switch. The ON and OFF switches operates two components:
the PCM's ON/OFF input, and the battery voltage to the brake switch, which powers the speed control servo.
The individual switches cannot be repaired. If one switch fails, the entire switch module must be replaced.
