Stratus V6-2.5L VIN H (1997)
6. Using Special Tool MD 998767, or equivalent and a torque wrench on the tensioner pulley. Apply 4.4 Nm (38.9 inch lbs.) of torque to tensioner.
Tighten tensioner pulley bolt to 48 Nm (35 ft. lbs.).
7. With torque being applied to the tensioner pulley install the tensioner to the tensioner pulley bracket and tighten fasteners to 23 Nm (205 inch
lbs.).
8. Pull tensioner plunger pin.
9. Rotate crankshaft 2 revolutions in a clockwise direction ONLY and check the alignment of the timing marks. Install tensioner pin into assembly.
The pin should slide in and out without any resistance. If the pin does not slide freely, perform the procedure again.
10. Install front half of timing cover and engine mount bracket.
11. Install right engine mount.
12. Remove jack from under engine.
13. Install crankshaft damper and crankshaft damper bolt and tighten to 182 Nm (134 ft. lbs.).
14. Install accessory drive belts.
15. Raise vehicle on hoist and install right inner splash shield.
