Stratus V6-2.5L VIN H (1997)
12. Connect the steering column intermediate shaft on the shaft of the steering gear. Install the coupler retaining pinch bolt and tighten to a torque of 27
Nm (240 inch lbs.). Be sure to install the coupler retaining pinch bolt retention pin.
13. Start the engine and let run for a few seconds. Then turn the engine off.
14. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
15. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops.
16. Add power steering fluid if necessary.
17. Stop the engine. Check the fluid level and refill as required.
18. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
