Stratus V6-2.5L VIN H (1997)
1. Install the CAB and the mounting bracket assembled, on the right inner fender of the vehicle.
2. Install the 2 bolts mounting the CAB bracket to the vehicle. Tighten both mounting bolts to a torque of 9 Nm (75 inch lbs.).
3. Install 60-way wiring harness connector into the CAB 60-way connector by hand until seated as far as possible. Then use CAB connector retaining
bolt to fully seat wiring harness connector into the CAB.
4. Tighten the 60-way connector retaining bolt to a torque of 4 Nm (35 inch lbs.).
