Stratus V6-2.5L VIN H (1997)
Control Module: Service and Repair
General Information
Do not interchange Transmission Control Modules with previous-year transmission control modules. If a same year TCM is being used from a different
vehicle, the following procedures must be performed:
-
Quick Learn Procedure
-
Electronic Pinion Procedure
The Transmission Control Module is located on the right fender inner panel, in the engine compartment. It is held in place by four mounting screws.
NOTE: If the Transmission Control Module has been replaced, the following procedures must be performed:
-
Quick Learn Procedure: This procedure will allow the transmission control module to learn the characteristics of the vehicle.
-
Electronic Pinion Factor Procedure: This procedure will reprogram the TCM to compensate for different tire sizes and final drive ratios.
