Stratus V6-2.5L VIN H (1997)
Alignment: Service and Repair
FRONT WHEEL TOE AND REAR WHEEL TOE AND CAMBER SETTING PROCEDURE
1. Prepare vehicle as described in the-Pre-Alignment Vehicle Inspection procedure.
2. Center steering wheel and lock in place using a steering wheel clamp.
NOTE: When performing the Front Toe and Rear Camber and Toe setting procedure, the rear wheel Camber and Toe MUST be set to the
preferred specification first, then set front wheel Toe to the preferred specification.
CAUTION: Do not attempt to straighten or repair a lateral link. Do not apply heat to the lateral link adjusting screws or to the jam nuts, when
loosening or adjusting the lateral links.
3. Loosen the adjusting screw jam nuts on all 4 of the rear lateral arm adjusting screws.
CAUTIONS:
-
Do not attempt to move the adjusting screws without properly loosening the jam nuts. Note that each adjusting screw has one right-handed nut
and one left-handed nut.
-
When setting rear Camber and Toe on the vehicle, the maximum lengths of the adjustable lateral link at the locations shown must not be
exceeded. If these maximum lengths are exceeded, inadequate retention of adjustment link to the inner and outer link may result.
