Stratus V6-2.5L VIN H (1997)
10. Position power steering pressure hose in outlet fitting of power steering pump, so hose is not contacting the pulley of power steering pump drive
belt. The tighten tube nut to a torque of 31 Nm (275 inch lbs.).
11. Install heat shield on hydraulic control unit for the antilock brake system.
12. Install accessory drive splash shield in right front inner fender.
13. Install tire back on vehicle. Tighten the wheel lug nuts in proper sequence until all lug nuts are torqued to half specification. Then repeat tightening
sequence to full specified torque of 129 Nm (95 ft. lbs).
14. Lower vehicle.
CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar (R), Power Steering Fluid, or equivalent.
