Stratus V6-2.5L VIN H (1997)
3. Install Special Tools assembled for installation of rear isolator bushing into lower control arm on the lower control arm. Be sure Special Tool 6756
is square on lower control arm and Special Tool 6760, or equivalents is positioned correctly on isolator bushing.
4. Tighten screw on Remover/Installer Special Tool C-4212-F, or equivalents pressing rear bushing into lower control arm. Continue pressing rear
bushing into lower control arm until bushing is sitting flush on the machined surface of the lower control arm. This will correctly position rear
bushing in lower control arm.
5. Install lower control arm assembly back on vehicle.
