Stratus Coupe L4-2.4L VIN G (2003)
1. Disconnect column switch connector C-203 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance between terminal 4 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES : Go to Step 8.
NO : Go to Step 6.
STEP 6. Check the column switch connector C-203 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is column switch connector C-203 in good condition?
YES : Go to Step 7.
NO : Repair or replace the damaged components). Refer to Harness Connector Inspection. Confirm the DTC 12 is not displayed. See: Diagrams
