Stratus Coupe L4-2.4L VIN G (2003)
STEP 2. Check the input signal (by using scan tool MB991502).
Check the input signals from the windshield wiper switches.
CAUTION : To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Check that the tone alarm of scan tool MB991502 sounds when the input signal enters.
Q: Does the tone alarm of scan tool MB991502 sounds when the input signal enters?
YES : Go to Step 4
NO : Scan tool MB991502 does not sound when the windshield wiper switch is turned from "OFF" to "MIST", "INT", "LO" or "HIGH":
Refer to Inspection Procedure O-16 "The windshield mist wiper switch, windshield intermittent wiper switch, windshield low-speed wiper
switch, windshield high-speed wiper switch or windshield washer switch signal is not sent to the ETACS-ECU."
STEP 3. Check the input signal (by using a voltmeter).
Check the input signals from the windshield wiper switches.
1. Use special tool MB991529 to connect a voltmeter between ground terminal 4 or 5 and ETACS-ECU terminal 9 of the data link connector.
2. Check that the voltmeter indicator deflects once when the input signal enters.
Q: Does the voltmeter indicator deflect?
YES : Go to Step 4.
NO : The voltmeter needle does not fluctuate when the windshield wiper switch is turned from "OFF" to "MIST", "INT", "LO" or "HIGH":
Refer to Inspection Procedure O-16 "The windshield mist wiper switch, windshield intermittent wiper switch, windshield low-speed wiper
switch, windshield high-speed wiper switch or windshield washer switch signal is not sent to the ETACS-ECU."
STEP 4. Check the windshield wiper motor.
