Stratus Coupe L4-2.4L VIN G (2003)
NOTE: Also check intermediate connector C-209, junction block connectors C-311 and C-312 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If intermediate connector C-209, junction block connector C-311 or C-312 is damaged, repair or replace the damaged
components) as described in Harness Connector Inspection.
Q: Is the wiring harness between front-ECU connector A-11X (terminal 24) and the ignition switch (ACC) in good condition?
YES : No action is necessary and testing is complete.
NO : The wiring harness may be damaged or the connector may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the windshield wiper works normally.
Inspection Procedure G-2
INSPECTION PROCEDURE G-2: Windshield Wiper and Washer: Any of the windshield wiper switch positions is defective.
WINDSHIELD WIPER MOTOR DRIVE CIRCUIT
-
Refer to Inspection Procedure G-1 "Windshield wiper does not operate."
CIRCUIT OPERATION
A signal from the windshield wiper switch is sent through the column-ECU inside the column switch to the front-ECU. The signal turns on the relay
