Stratus Coupe L4-2.4L VIN G (2003)
1. Disconnect the ETACS-ECU connector C-318 and measure at the wiring harness side.
2. Connect terminal 72 to the ground.
Q: Does the high-beam indicator light illuminate?
YES : Go to Step 10.
NO : Go to Step 3.
STEP 3. Check the high-beam indicator light bulb.
Q: Is the high-beam indicator light bulb in good condition?
YES : Go to Step 4.
NO : Replace it. The high-beam indicator light should work normally.
STEP 4. Check the combination meter (printed-circuit board).
1. Remove the combination meter.
2. Remove the high-beam indicator light bulb. Then measure the resistance between the bulb terminals.
