dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Component Tests and General Diagnostics|Page 2388 > < Component Tests and General Diagnostics|Page 2386
Page 193
background image

2. Measure the voltage between terminal 11 and ground. 

-

The voltage should equal approximately 12 volts (battery positive voltage).

Q:  Is the measured voltage approximately 12 volts (battery positive voltage)?

YES :  Replace the ETACS-ECU. The turn-signal lights should flash normally. 

NO :  Go to Step 5.

STEP 5. Check the ETACS-ECU connector C-319 for loose, corroded or damaged terminals, or terminals pushed back in the connector. 

Q:  Is ETACS-ECU connector C-319 in good condition?

YES :  Go to Step 6.

NO :  Repair or replace the damaged components). Refer to Harness Connector Inspection. The turn-signal lights should flash normally.

Component Tests and General Diagnostics|Page 2388 > < Component Tests and General Diagnostics|Page 2386