Stratus Coupe L4-2.4L VIN G (2003)
STEP 10. Check the wiring harness between theft-alarm horn relay connector A-06X and theft-alarm horn connector A-25.
Q: Is the wiring harness between horn relay connector A-06X and theft-alarm horn connector A-25 in good
condition?
YES: Go to Step 11.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged , terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The theft-alarm horn should sound when the theft-alarm system is triggered.
2002Models
STEP 11. Check that the theft-alarm horn is installed properly.
NOTE: The theft-alarm horn is grounded to the body through the installation bolts.
Q: Is the theft-alarm horn installation in good condition?
YES : Replace the ETACS-ECU. The horn should sound when the theft-alarm system is triggered.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The horn should sound when the theft-alarm system is triggered.
Inspection Procedure N-3
INSPECTION PROCEDURE N-3: Theft-alarm system: Headlights (high-beam) do not flash when the theft-alarm system is triggered.
TECHNICAL DESCRIPTION (COMMENT)
If the headlights (high-beam) work normally, the front-ECU or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-
The front-ECU may be defective
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
STEP 1. Verify the headlight (high-beam) operation.
Q: Do the headlights (high-beam) illuminate normally?
YES : Go to Step 2.
NO : Solve the problem first. See: Diagnosis By Symptom
STEP 2. Replacement of ECU
1. Replace the ETACS-ECU.
2. The headlights (high-beam) should flash when the theft alarm system is triggered.
Q: Do the headlights (high-beam) flash normally by the theft-alarm system?
YES : No action is necessary and testing is complete.
NO : Replace the front-ECU. The headlights (high-beam) should flash when the theft-alarm system is triggered.
Inspection Procedure N-4
INSPECTION PROCEDURE N4: Theft-alarm system: Panic alarm function does not work.
TECHNICAL DESCRIPTION (COMMENT)
If the keyless entry system is normal, the ETACS- ECU is defective.
TROUBLESHOOTING HINTS
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
