Stratus Coupe L4-2.4L VIN G (2003)
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The key reminder switch input signal should be able to be checked and the functions, which are
described in the Technical Description (comment),' should work normally.
STEP 2. Check the ground circuit to the key reminder switch. Test at key reminder switch connector C-201.
1. Disconnect the key reminder switch connector C-201 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance between terminal 4 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES : Go to Step 5.
NO : Go to Step 3.
STEP 3. Check the key reminder switch connector C-201 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is key reminder switch connector C-201 in good condition?
YES : Go to Step 4.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. See: Diagrams/Diagnostic AidsThe key reminder switch
input signal should be able to be checked and the functions, which are described in the 'Technical Description (comment),' should work normally.