Stratus Coupe L4-2.4L VIN G (2003)
1. Disconnect driver's door lock key cylinder switch connector E-14 and measure at the wiring harness side.
2. Measure the resistance between terminal 2 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES : Go to Step 6.
NO : Go to Step 4.
STEP 4. Check the driver's door lock key cylinder switch connector E-14 for loose, corroded or damaged terminals, or terminals pushed
back in the connector.
Q: Is driver's door lock key cylinder switch connector E-14 in good condition?
YES : Go to Step 5.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The input signal from the driver's door lock key cylinder
switch should be able to be checked and the functions, which are described in the 'Technical Description (comment),' should work normally.
