Stratus Coupe L4-2.4L VIN G (2003)
the Technical Description (comment),' should work normally.
STEP 3. Check the ground circuit to the driver's door lock actuator switch. Test at driver's door lock actuator switch connector E-13.
1. Disconnect driver's door lock actuator switch connector E-13 and measure the resistance available at the wiring harness side.
2. Measure the resistance between terminal 1 and ground of the connector.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES : Go to Step 6.
NO : Go to Step 4.
STEP 4. Check the driver's door lock actuator switch connector E-13 for loose, corroded or damaged terminals, or terminals pushed back in
the connector.
Q: Is driver's door lock actuator switch connector E-13 in good condition?
YES : Go to Step 5.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The input signal from the driver's door lock actuator
switch should be able to be checked and the functions, which are described in the Technical Description (comment),' should work normally.
