Stratus Coupe L4-2.4L VIN G (2003)
STEP 5. Check the wiring harness between power window main switch connector E-12 (terminal 9) and ground.
NOTE: Also check intermediate connector C-211 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-211 is damaged, repair or replace the damaged components) as described in Harness Connector Inspection.
Q: Are the wiring harness between power window main switch connector E-12 (terminal 9) and ground in good condition?
YES : No action is necessary and testing is complete.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The door lock switch input signal should be able to be checked and the central door locking system
should work normally.
STEP 6. Check the power window main switch connector E-12 and ETACS-ECU connector C-317 for loose, corroded or damaged terminals, or
terminals pushed back in the connector.
Q: Are power window main switch connector E-12 and ETACS-ECU connector C-317 in good condition?
YES : Go to Step 7.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The door lock switch input signal should be able to be
checked and the central door locking system should work normally.
STEP 7. Check the wiring harness between power window main switch connector E-12 (terminal 3 and 10) and ETACS-ECU connector C-317
(terminal 33 and 34).
NOTE: Also check intermediate connector C-211 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
