Stratus Coupe L4-2.4L VIN G (2003)
<<C>> STEERING WHEEL REMOVAL
CAUTION: Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.
Using the special tool MB990803, remove the steering wheel.
<<D>> CLOCK SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean and dry place.
<<E>> AIR BAG MODULE REMOVAL (PASSENGER'S SIDE)
WARNING: The removed air bag module should be stored in a clean and dry place with the pad cover face up.
INSTALLATION SERVICE POINTS
>>A<< PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.
1. When installing the new air bag modules and clock spring, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition, switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
3. Connect scan tool MB991502 to the data link connector.
4. Turn the ignition switch to the "ON" position.
5. Conduct diagnostic test using scan tool MB991502 to ensure entire SRS operates properly.
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
6. Turn the ignition switch to the "LOCK" (OFF) position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental
connection and air bags deployment.
