Stratus Coupe V6-3.0L VIN H (2001)
3.
Disconnect the wire harness connector from the blower motor resistor (Fig. 1).
4.
Remove the two screws that secure the blower motor resistor to the HVAC housing and remove the resistor.
5.
Use a hot knife or similar tool to the enlarge the blower resistor opening in the HVAC housing so that the opening matches the inside edge of
raised rib around the opening, (Fig. 2).
NOTE:
Remove any/all debris from the HVAC housing.
6.
Position the blower motor resistor into the bottom of the HVAC housing.