dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Lighting System Diagnosis|Page 5924 > < Lighting System Diagnosis|Page 5922
Page 3
background image

STEP 2. Check the daytime running light-ECU connector A-26 for damage.

Q: Is daytime running light-ECU connector A-26 in good condition?

YES: Go to Step 3
NO: Repair or replace it. Refer to Harness Connector Inspection. The speedometer should work normally.

STEP 3. Check the harness wires between daytime running light-ECU connector A-26 and battery.

Q: Are the harness wires between daytime running light-ECU connector A-26 and battery in good condition?

YES: Go to step 4.
NO: Repair or replace it. Refer to Harness Connector Inspection.

STEP 4. Check the daytime running light-ECU power supply circuit (IG2) at the daytime running light-ECU A-26.

1. Disconnect the daytime running light-ECU.
2. Turn the ignition switch "ON" position.

3. Measure the resistance between terminal 2 and ground.

Q: Is the voltage 12 volts (battery positive voltage) between terminal 2 and ground?

YES: Go to Step 7.
NO: Go to Step 5.

Lighting System Diagnosis|Page 5924 > < Lighting System Diagnosis|Page 5922